A Simple Fix for a Sticking A111 Button
Daniel W
A customer reported a sticking VHF1 button on their Rowsfire A111. The issue was caused by the top plate screws being too tight, which compressed the button housing. By removing...
The build quality of the A113 v1 panel is great and everything works as advertised with the Rowsfire app. The Flood Light dial is a little jittery.
The build quality of the A112 v1 panel is great. Everything works fine with the Rowsfire app. Only point of improvement is to find a way to calibrate the GAIN and TILT dials on the panel so they match the position of the dials in the simulator, they are now way off and jitter a little. Both the Light dials are also jittery.
The build quality of the A111 v1 is great, but for a “1:1” panel it misses a lot of functionality. None of the radio buttons have the blinking annunciators for CALL/MECH/ATT, and none of the dials light up when a channel is active (so you still have to select your pedestal view in your simulator to check). Also, the INT/RAD switch is not momentary for the RAD position.
The panel works great with the Rowsfire app, but with Mobiflight the dials produce so much noise that Mobiflight constantly restarts.
If I would have known about the missing functionalities I may not have bought this panel.
Shipping protection It was great!. Devices Configuration were quite complicated (A112 and A113). Still working on.the tbacklight of both devices that stop working next day of its installation.
Finally all complete. After small starting issues now working smooth with rowsfire app all my 3 rowsfire units 👍