Text display issue and incorrect text on Onlykey App SETUP tab

[SmartlyCautionMaybe]

ENVIRONMENT:
Onlykey app 5.5.0, installed via .deb
OS: Linux Mint 21.1 (vera)
Used with: OnlyKey v3.0.4-prodc

ISSUE:
The OnlyKey App SETUP tab text displays as shown in the attached screenshot:

However, if you copy and paste that text block elsewhere, it shows the following content:

"Before selecting an option below, you must first put your OnlyKeyDUO into config mode.
To do this hold down button #6 on your OnlyKey for 5+ seconds and release. hold down button #1 on your OnlyKey DUO for 10+ seconds and release.The light will turn off. If a PIN was previously set, re-enter the PIN to enter config mode.You will notice the OnlyKey flashes red in config mode."

RECOMMENDED CHANGE:

1. Fix formatting so correct text is displayed
2. Correct inconsistencies between OnlyKEY and OnlyKey DUO
3. Fix capitalization typo ("... and release. Hold down Button 1 ..."

Potential replacement text (I cannot confirm this is correct for the OnlyKey DUO):

"Before selecting an option below, you must first put your OnlyKey or OnlyKey DUO into config mode.
To do this,

• Hold down button 6 on your OnlyKey for 5+ seconds and release
• Hold down button 1 on your OnlyKey DUO for 10+ seconds and release.

The light will turn off. If a PIN was previously set, re-enter the PIN to enter config mode. You will notice the OnlyKey or Onlykey Duo flashes red in config mode."

Thanks.

[IGLOU-EU]

Hi, this is probably an application issue and not a firmware one