OpenWrt firmware installer

Marlin is a firmware for RepRap 3D printers optimized for both 8 and 32 bit microcontrollers. Marlin supports all common platforms. Many commercial 3D printers come with Marlin installed. Check wit…

Configurations for Marlin Firmware

Simple EFI bootloader

💻 🔒 🔑 Secure Boot key manager

Custom, unlocked bootloader for ASUS MeMO Pad 7 (ME176C(X))

SNANDer - Serial Nor/nAND/Eeprom programmeR (based on CH341A)

Flashrom/serprog compatible firmware for the Raspberry Pi Pico

flashrom serprog programmer based on STM32 MCU & USB CDC protocol. Uses libopencm3 and deprecates the old serprog-stm32vcp project.

esp8266 wifi-serial bridge, outbound TCP, and arduino/AVR/LPC/NXP programmer

Scripts for setup/install/firmware update for ChromeOS devices

Libre Mainline Kernel and Debian for arm laptops

Tiny FEL tools for allwinner SOC, support RISC-V D1 chip

Zero-cost and safe interface to UEFI firmware

Open source STM32 MCU programming toolset

grblHAL core code and master Wiki

A C++ bare metal environment for Raspberry Pi with USB (32 and 64 bit)

Dexed FM synthesizer similar to 8x DX7 (TX816/TX802) running on a bare metal Raspberry Pi (without a Linux kernel or operating system)