Hi @jhfoo2

well, in my case, without the 1 second delay the UI label wasn't fully updated on the display. Or in other words, ESP32 already went into light sleep while in the background the display was still finishing to update. (In your case it might be ok without the delay as the print() takes some time.)

I think the reason for not getting the touched X, Y is that internally the wake-up code already read the touch IC registers and by doing so cleared the values. But I could be wrong about that as it is simply a guess.

Thanks
Felix

Hello @Wambo6000

maybe you are hearing what's described on the product page here: "Abnormal Device Noise".

Thanks
Felix

Hello @jhfoo2

please have a look at the UIFlow2 Project Zone example I created: M5PaperS3_Light_Sleep_Test_UIFlow2.4.3

Thanks
Felix

Hi guys

I looked at some of the comments - they are all dated from last year. I did not see anything recent. That makes me believe that the commenting feature has been turned off.

Thanks
Felix

Hello @alex9

it looks like yes, GPIO0 is TX pin for RS485. See pinmap here.

The platformio.ini example can be found here.

Running a quick search I did not find an RS485 example, sorry.

Edit: Maybe try this RS485 library.

Thanks
Felix

Hello @JohnSal

I think you only need to add one RGB unit but with number set to 6 instead of 3.

Thanks
Felix

Hello @HappyUser

just curious, which SIM module did you settle on?

Thanks
Felix

Hello @hotellonely

yes, it looks like the drop-down box needs fixing. In the mean time you can use all GPOs on the 14 pin header via some custom code blocks.

I created an example in UIFlow2 Project Zone called M5CardputerAdv_ExtPin_Test_UIFlow2.4.2

Thanks
Felix

Hi guys

I can confirm receiving IR from Unit IR is broken for M5Core2 as well.

Thanks
Felix

Hello @MitchBuckanon

like @robski mentioned, M5Dial has two ports: A and B which gives you 4 GPIOs you can use. In my test I configured the GPIOs like below:

#define ETH_PHY_CS    1
#define ETH_PHY_IRQ  -1
#define ETH_PHY_RST  -1
#define ETH_SPI_SCK  13
#define ETH_SPI_MISO 15
#define ETH_SPI_MOSI  2

Below is how I wired M5Dial to the LAN module (using a Bus Module) and some Grove/Dupont cables.

Hope this helps.

Thanks
Felix